 |
1.02 Short Tee
The short tee is designed to give a 90° butt joint between two pipes. This fitting cannot be used to join horizontal pipes within the fitting. |
 |
1.02C Short Tee - Capped
The reducing capped tee is designed to give a 90° butt joint between a post upright and a rail. This fitting can be used at the beginning or end length of the rail offering a neater looking profile than a standard short tee.
|
 |
1.03 Short Tee 0°-11°
The Short Tee 0° – 11° is typically used for attaching rails to posts when constructing a handrail on a slope. |
 |
1.04 Long Tee
The long tee is designed to give a 90° butt joint between two pipes. This fitting should be used where a join is required between the horizontal pipes, as the sleeve holds two grub screws. |
 |
1.05 Internal Swivel Tee
The internal swivel tee 360° is designed to allow for variable angles on structures.
|
 |
1.06 Long Tee 0°-11°
The long tee 0o to 11o degree is designed to give a variable anglebutt joint between two pipes. This fitting should be used where a join is required between the horizontal pipes, as the sleeve holds two grub screws. |
 |
1.07 Adjustable Tee 30°-60°
The adjustable tee 30° – 60° is used for struts and bracing in structures. It can be used at any selected angle between 30° and 60°. |
 |
1.08 Clamp-on Tee
The clamp-on tee is designed to give a 90° joint between two pipes. Because of the bolt construction it is an easy add-on fitting for existing structures. |
